I am trying to replace the controller on the clubCare listed above. Does anyone know if the "Performance Plus Carts - Curtis 1204 Controller 325 Amp Series for Club Car DS Golf Carts - fits 1996-up" is compatible with this cart? I think this model cart is also rare as it has two 48V solenoids as well. Any help would be appreciated. Thank you!
yep.... you have a regen 1 cart ( Regenerative braking )
no the Curtis 1204 Controller 325 Amp does not fit
you need a 575 GE Speed Controller 300 Amps for Club Car Regen 1
or the 500 amp controller
attached is your wiring diagram
no the Curtis 1204 Controller 325 Amp does not fit
you need a 575 GE Speed Controller 300 Amps for Club Car Regen 1
or the 500 amp controller
574 GE Speed Controller 500 Amp for Club Car Regen 1
574 GE Speed Controller for Club Car Regen 1
www.cartszone.com
attached is your wiring diagram
wiring is the same
see the plug in the photo ?? the new one comes with new adapter plug
one thing that you need to do is drill new holes for controller to mount to frame (upside down)
i did find a cheaper controller $254.00
also an install video (sort of )
ok so here is why you have a solenoid with a coil ... it is for slower speed in reverse
some people by-pass the coil for full speed reverse
i have the wiring diagram for reverse solenoid removal if needed
V-glide wiring
see the plug in the photo ?? the new one comes with new adapter plug
one thing that you need to do is drill new holes for controller to mount to frame (upside down)
i did find a cheaper controller $254.00
also an install video (sort of )
ok so here is why you have a solenoid with a coil ... it is for slower speed in reverse
some people by-pass the coil for full speed reverse
i have the wiring diagram for reverse solenoid removal if needed
V-glide wiring
Last edited:
qoute MAaster Cylinder "The second solenoid with the coil is not a reverse solenoid for slower speed it is the regen solenoid."
what the fuck ???...
come on smart boy ... you should know better
you are giving bad info
you are banned for a month
the regen comes out of the end of the motor
www.pmdcorp.com
what the fuck ???...
come on smart boy ... you should know better
you are giving bad info
you are banned for a month
the regen comes out of the end of the motor
Regenerative Braking - Part I: Steady State Analysis
What conditions can battery regeneration occur? Learn about regenerative braking and the analysis of a battery powered vehicle operating at a steady state.
Last edited:
So I replaced the controller with the one recommended. I also replaced both solenoids. The cart runs but the speed remains very slow. If I bypass the resister coil would that eliminate the issue with the low speed? I know the speed controller is inside the motor for this cart, so it isn’t like the newer motors where I can just switch it out with a new one via plug and play. The cart does not have the V-glide. I’m not sure how to correctly bypass the resistor coil if that is an option. The diagram seems to be eliminating an entire solenoid. Sorry for all the questions, I’m certainty a newbie trying to figure this out….thanks in advance for any suggestions.
that is only the slow speed reverse coil
take a cable from A2 controller to A2 motor remove the coil and solenoid tape off small wires
how slow is slow? the regen1 cart will only go 15 mph
your wiring diagram is the first one i attached
one thing to check is the front wheel brings should be free wheeling when jacked up
check for a rub mark on inside of rim
check rear brakes for drag
take a cable from A2 controller to A2 motor remove the coil and solenoid tape off small wires
how slow is slow? the regen1 cart will only go 15 mph
your wiring diagram is the first one i attached
one thing to check is the front wheel brings should be free wheeling when jacked up
check for a rub mark on inside of rim
check rear brakes for drag
Thank you! It tops out at 5 mph. The cart feels like it wants to go but just peaks out at maybe 5 mph. Going up a hill it slows down to 1 mph, it doesn't stop but simply moves at a walking pace. I will check for the rear brake drag. I checked the front wheels and they are free moving when on jack stands. I will also try eliminating the slow speed reverse coil and second solenoid. Thanks again!
you can replace the speed sensor on the end or the motor
yep ... there's a speed magnet in there
i would put a high speed magnet in
text my friend David @ Ratrevolution Golf Cars.
Text: 706-431-3917
tell him that Crash Test Dummy is helping you and you need a high speed magnet
tell him you have a regen 1 cart
he will sell you the correct speed magnet
i would put a high speed magnet in
text my friend David @ Ratrevolution Golf Cars.
Text: 706-431-3917
tell him that Crash Test Dummy is helping you and you need a high speed magnet
tell him you have a regen 1 cart
he will sell you the correct speed magnet
Last edited:
I AM HERE WHEN YOU NEED ME .... OH YOUR FRIENDS
I HAVE ABOUT 20 YEARS WORKING ON CARTS ...
HOW ABOUT PHOTOS ??
David
I HAVE ABOUT 20 YEARS WORKING ON CARTS ...
HOW ABOUT PHOTOS ??
David
